50w 6 ohm load resistor.
How to install load resistors for led turn signal lights.
Simply wire the resistor between the ground wire and the.
Load resistors also have no negative or positive making it easier for you because you wouldn t have to worry about which wires goes to which side.
A load resistor is required for each led light bulb in the turn signal circuit you may only want to upgrade the rear of the vehicle.
Always mount the load resistor to metal using zip ties not double sided tape.
If you have any questions leave a comment below and i ll do my best to answe.
In sum 1 merge the wire together instead of using t tap to ensure perfect connection 2 always try different combinations for double filament bulbs at most 3 combinations 3 mount the resistor to metal to prevent any heat damage.
The load resistor goes across the light bulb connections between the supply and ground.
These circuits are simple to understand and therefore riders prefer installing the led lights themselves.
Fortunately any motorcycle with a regular 12 volt direct current circuit can accommodate led turn lights.
To add a load resistor to an indicator turn signal it has to be wired into each led light bulb in parallel.
This video is a guide showing the proper way to wire led turn signal resistors.
You will need 50w 6 ohm load resistors and tap the load resistor to the stock harness in parallel.
Therefore many riders prefer replacing the old turn signals with led lights to save money.